Wiring a WMC-2000 load cell to DEWE43a

Looking for some assistance wiring and doing a 2-point calibration for an 'Interface Force' brand load cell, part number WMC-2000. Attached is the calibration sheet and wiring diagram. Please help! Thank you.

Dear Scott,

In the image below I have prepared a connection diagram for the load cell:

You can set a two point scaling in the channels setup:

Then you can use a known mass to check the result.

For more information, we also have a full bridge measurement of strain and force tutorial. 

Best regards.

Rok

@Rok Kmetič - Thank you Rok!!